Phone：(+86)189 1548 0537
Phone
◆ Suitable for resistive and inductive loads
◆ CE certification
| 1 |
Load Control Element |
hyristor (SCR) Module |
| 2 |
Load Power Supply |
Single-phase 220V AC Three-phase 380V AC ±10% 50HZ |
| 3 |
Control Input |
4～20mA input, receiving impedance 120Ω |
| 4 |
Output Resolution |
Phase Control: 0.6°； Power Control: 20ms |
| 5 |
Phase Shift Range |
0～175° |
| 6 |
Drive Output |
1). Output: 12V pulse, variable pulse width, maximum drive current: < 30mA. Compatible with P-type SSR, integrating voltage regulation/power control functions. 2). Pulse transformer output: slotted pulse, compatible with MKK/MTC anti-parallel modules, enabling single-phase voltage regulation and full-control rectification, but without power control mode. |
| 7 |
LED Status Indicator |
Green： INPUT signal linear indicator light. Tricolor status lights： RUN green operation light； ALM red alarm light； STOP yellow flashing standby light。 |
| 8 |
Soft Start and Soft Shutdown RS for External Actuator Switch
|
No Voltage Contact Input
|
| 9 |
Automatic soft start and emergency stop during operation
|
Emergency stop due to overcurrent or overtemperature during operation, with the protection response time for overcurrent and overtemperature not exceeding one power cycle (20ms). |
| 10 |
70℃ Overtemperature Protection |
Voltage-free Normally Closed Contact |
| 11 |
Alarm Relay |
One set of normally open contacts (pure resistance 1A 250VAC). |
| 12 |
Alarm Type |
Overcurrent, Heatsink Overtemperature. |
| 13 |
CT Maximum Current Limit |
External 10K potentiometer, adjustment range 20% to 100%. |
| 14 |
Overcurrent Protection |
Adjusted by internal potentiometer P2. Reference point 1V； |
